Dynaudio SUB 250 COMPACT Manuel d'utilisateur télécharger pdf (Page 10)

Operation

8 Dynaudio Sub 250

Connecting a single subwoofer

➊ To connect the SAT/SUB input:

X From the preamplifier output of your processor/receiver, PC or mediaplayer (often

marked as Pre Out or Front Out) connect a stereo RCA cable to the subwoofer

SAT/SUB Input.

This signal should not be already processed by the processor/receiver. Please pay

attention to the settings of your processor/receiver.

➋ To connect the LFE channel:

X From the processor or receiver’s low-level (not a speaker output) subwoofer output

(often marked as “subwoofer out”, “Sub out” or “LFE”), connect a mono RCA-to-

RCA cable to the subwoofer input SUB I/O - LFE/Slave In.

This signal should not be already processed by the processor/receiver. Please pay

attention to the settings of your processor/receiver.

X Set the MODE switch to LFE.

Note: You also can use both connection types. Both signals will be combined in the

Sub 250 and routed accordingly. This allows the Sub 250 to reproduce both

the LFE channel information as well as the bass range of the connected

satellite speakers

Multiple subwoofer connections

The Dynaudio Sub 250 can be used stand-alone or together with multiple subwoofer

units. Using multiple units may be helpful if the listening room is quite large or has

difficult acoustic conditions (e.g. room-modes, see also “Positioning the subwoofer”

on page 12 for further information).

When using two or more subwoofers, the first one (designated “Master”) controls the

following subs (designated “Slave”) via a subwoofer cable.

To connect multiple subwoofers:

1. Connect the first subwoofer with the processors/receiver as described before.

2. Set MODE switch of first subwoofer to LFE.

3. From the SUB I/O - LFE/To Slave output of the first subwoofer connect a mono

RCA-to-RCA cable to the SUB I/O - LFE/Slave In input of the following

subwoofer. This now becomes the slave.

4. Set the MODE switch of the second subwoofer to Slave.

X Further subwoofers can be connected in the same way. Set the MODE switch of

all following subwoofers to Slave respectively.

Note: In order to avoid interference and noise, we recommend you use quality, well

shielded cables.

When using multiple subwoofers in a Master-Slave setup, it is recommended

that the subwoofers are all the same model.

If you wish to use multiple subwoofers with full individual control, set the Input

switch for all to the “Master” position. From the Amplifier, processor or

receiver’s subwoofer output, use a Y-connector.

➊

➋

LFE/SUB OutFront Out/

Pre Out

Sub 1

(Master)

Sub 2

(Slave)

Sub...

(Slave)

LFE/SUB Out

Front Out/

Pre Out

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Dynaudio SUB 250 COMPACT Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Microphones Dynaudio SUB 250 COMPACT